|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
09-08-2018, 04:36 PM
|
|||
|
|||
Top end rebuild, lots of orings?
Hi folks,
Finishing off a top end on my mates 03 300. In the gasket kit i have base gaskets, powervalve cover gaskets, reed gaskets, exhaust Orings and gasket, water pump gaskets and head o rings. There is also 7 other Orings. Where do they go? I didn't remove any this size. See pic attached Cheers 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cylinder orings | Cox76y | General Discussions & Announcements | 2 | 05-13-2016 07:07 AM |
| Gnarly orings ec300 | GregS | Enduro Engine - 2 stroke | 3 | 12-01-2014 07:15 PM |
| exhust springs and orings | chinesegav | United Kingdom | 9 | 05-24-2013 06:51 AM |
| fork bleeder screws and orings | flybars | General Discussions & Announcements | 9 | 09-10-2012 07:28 AM |
| Head orings | Brian VT | Enduro Engine - 2 stroke | 5 | 09-05-2008 11:49 AM |
Threaded Mode