Setting Crank/Bearing depth when assembling - Page 2 - Rieju & GasGas Legacy Riders Club Forum

		Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke
Setting Crank/Bearing depth when assembling

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.

Page 2 of 2

#11

02-25-2011, 07:32 PM

CDBiker220 CDBiker220 is offline

Senior Member

Join Date: Nov 2010

Posts: 119

Being poor is mostly the factor behind my decisions. It still had 185 psi cold before i tore it down. Probably doesnt even need it.

Page 2 of 2

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ignition side crank bearing failure?	wence	Enduro Engine - 2 stroke	37	06-16-2016 07:21 PM
Crank bearing spinning in case...	CDBiker220	Enduro Engine - 2 stroke	8	02-16-2011 11:53 AM
07 Crank bearing... NEED URGENT HELP.	wence	Enduro Engine - 2 stroke	11	05-23-2010 02:25 PM
03 EC300 crank bearing problem	bwalker98	Enduro Engine - 2 stroke	4	05-04-2010 05:05 PM
2007 EC250 Crank Bearing?	BIG TOOL	Enduro Engine - 2 stroke	9	11-23-2007 02:47 AM

All times are GMT -5. The time now is 03:29 AM.