I think I need a motor pulldown??? - Page 2

NSE.ONE · #11 03-11-2011, 04:11 PM

6K had a buyer but turned out to be no good. ohwell

wence · #12 03-11-2011, 06:29 PM

Oh well , at least you will probably get six over there . I think I will be very lucky to get that in SA.
By the way here are some shots of the gearbox;

More to come,
Cheers Mark

wence · #13 03-11-2011, 06:52 PM

wence · #14 03-11-2011, 08:06 PM

wence · #15 03-11-2011, 08:08 PM

wence · #16 03-11-2011, 08:13 PM

Keg · #17 03-12-2011, 04:46 PM

Those dogs look pretty bruised mate. I am only viewing them on my phone but might be time for a gear or two.

wence · #18 03-12-2011, 09:59 PM

Looking that way mate...

wence · #19 03-15-2011, 04:32 AM

Oh well there you go.
Never run a motor low on oil. Pretty obvious unless you are out in the middle of nowhere trying to baby the bike to help.
This was over a year ago but the damage was done.
One selector is buggered, 5th and 6th gears stuffed and also first and the gear next to that.
All up four new gears needed and one selector plus all gaskets etc.....

I think I will keep the bike for a while now.
Cheers Mark

Keg · #20 03-15-2011, 03:20 PM

Have a good feel and look at all the gearbox bearings too. I would just replace them to be sure anyway!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
300 motor into 200 frame..	stainlesscycle	Enduro Engine - 2 stroke	7	05-10-2010 05:20 PM
Looking for someone in the USA to build a motor.	lvnspeed	Enduro Engine - 2 stroke	10	02-06-2009 07:46 PM