|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Headlight Bulb
I don't suppose any of you could do me a favor and take a picture of your headlight bulb properly installed from the backside. I took the bulb out, and now a couple weeks later I can't seem to figure out how the spring that holds it in place, fits in there......... don't ask, It's been a long week.
__________________
2010 GasGas EC 300 Nambotin Replica #141 2006 Honda XR650R Supermoto |
#2
|
||||
|
||||
These aren't great pictures but they should get you there. I taped the top of the housing in the second shot to attempt to cut down flash glare. The photos were taken from the top.
The screw is at the 9 o'clock position looking at the back of the bulb. The wire comes out from the back, plunging at 12 o'clock and then back out, running above the housing before the tail appears to locate into the housing at about 4 o'clock. Heading anti-clockwise from the screw, the wire runs straight against the back of the bulb roughly parallel with the ground at the bottom of the bulb. This tail terminates flat against the bulb. Hope this helps.
__________________
Steven Beane #275 PlusOnePerformance - Superior Service the World Over - Dearborn MI AMA District 14 (Michigan) Officer afterhourscycle.com Michigan's Beta and TM Race Headquarters |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FSE450 bulb | vwboomer | Enduro Electrical & Wiring | 1 | 04-01-2010 09:01 PM |
07 headlight? | wence | Enduro Electrical & Wiring | 4 | 11-23-2009 12:21 PM |
Bulb rating for 2001 ec300 | johns2394 | Enduro Electrical & Wiring | 0 | 12-02-2008 01:12 PM |
Headlight Help | loopole | Enduro Electrical & Wiring | 3 | 05-28-2008 02:08 PM |