|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
fuel/oil mix
what dose every one use i take it every ones uses premix? i use 50:1
|
#2
|
||||
|
||||
40:1 Yamalube 2r.
__________________
03 ec250 hyde skidplate, cycra handguads, protaper contours "what? it seemed like a good idea at the time!" |
#3
|
||||
|
||||
I am using Motul 800 at 32:1. More oil is better. Any oil will do honestly. The synthetics are all good. The blends have a lower flashpoint and therefore less groz dripping out the back and less fouling of the muffler packing. I like that, but still prefer the high end oil for peace of mind. I can deal with a little spooge, who cares?
__________________
Mike Sheetz OMRA #21AA What will I be riding next? Christini GG 300? '15 KTM 300 XC-W '08 EC 250 (Gone to new happy owner) Gran Prix Cycle LTR Suspension RB-Designs |
#4
|
|||
|
|||
Quote:
Thats alot of oil, I run 50:1 using this stuff |
#5
|
||||
|
||||
50:1 Amsoil Interceptor.
__________________
2004 GasGas DE250 |
#6
|
||||
|
||||
i switched 40:1 amsoil interceptor. i was running maxima at 50:1. 40:1 smokes a bit more, no spooge though.
|
#7
|
||||
|
||||
Amsoil interceptor 50/1 + a few drops... with a ton of spooge...I am now playing with the brass.
__________________
'O3 EC250 RED TRACTOR (Rear-trial tire Front-MotoZ Terrapactor) '89 KDX200 Indestructible (Worn out GG tires ) |
#8
|
|||
|
|||
45:1 or so interceptor. This seems to work best so far minimizing spooge.
__________________
2003 EC250 w/ Ohlins pkg Sometimes you eat the bear, sometimes the bear eats you. |
#9
|
||||
|
||||
Ok...what the deal here? The subject of oil ratio's and type of oil is more of a hot topic than Tiger Woods these days
My question is....does the ratio of oil and the type of oil cause "the drip"? ....or the liberal use of brass? Just asking out loud! Thanks
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals |
#10
|
||||
|
||||
Quote:
I run my 07 EC250 @ 50:1 MOTUL 800. I seem to be getting more spooge than any of my previous bikes, which I tended to run @ around 42:1 - same oil. I think it is largely related to jetting. I get almost no spooge if I ride all day on open trails where I spend a lot of time on the pipe. Riding slower more technical trails will give me more spooge. Although this sounds ass about face, it kind makes sense to me in that I am running a N1EG needle - I think this needle is a bit rich low down but it gives great pull through the midrange and transitions onto the pipe effortlessly. Does that make sense to you guys ?
__________________
Barry 07 EC250 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
E85 fuel | fkmf6 | General Discussions & Announcements | 29 | 01-20-2014 10:18 AM |
Fuel tap fault | Warwick Simpson | Enduro Intake/Carburetion - 2 stroke | 0 | 11-09-2008 12:15 AM |
Fuel and AV Gas | kim | Enduro Intake/Carburetion - 2 stroke | 22 | 07-04-2008 11:06 PM |
Fuel ? | west aussie gas 450 | Australia & New Zealand | 9 | 07-01-2008 04:51 AM |
Fuel range and fuel light | sanderjavant | Enduro Engine 4 stroke (including EFI & Exhaust) | 6 | 01-05-2008 02:35 AM |