|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Vibration
Vibration!!
The other day in the hills my son was being challenged on his CRF250, He was having a tough time so i told him to take my EC300 and i would ride his bike out of the tough areas. When he got on my bike he asked why it vibrated so bad i told him maybe because it is a 2 stroke instead of a 4 stroke. So than after about 20 miles on his bike we got back to the truck refilled and than i got back on mine and noticed the vibration he was talking about, is this normal? Never rode a 4 stroke that long before, is a lot of vibration common or should i be thinking something is wrong?
__________________
99 EC 250 - Gas Gas- sold 01 TXT 280 Gas Gas 07 EC 300 Gas Gas 88 Honda NX 250 |
#2
|
||||
|
||||
this kinda came up on here in the last couple of weeks... read this for reference
http://www.gasgasrider.org/forum/sho...ight=VIBRATION now that being said, my 300 vibrates. When i ride it alot, I don't notice it at all. The only time I do notice it, is when I hop on my WR450 and ride for a while, then get back on it.(those stinking 4t's are way smooth) Check all the stuff in that thread, you are probably fine. it is probably just the difference between those 2 bikes.. jay
__________________
broken down over 60 slow rider.. |
#3
|
|||
|
|||
Thanks for the reply jhendr, I will check out the other post..
__________________
99 EC 250 - Gas Gas- sold 01 TXT 280 Gas Gas 07 EC 300 Gas Gas 88 Honda NX 250 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Excess Vibration | case-racing | Australia & New Zealand | 3 | 05-30-2009 11:22 PM |
foot peg vibration | MIKEWA | Enduro Chassis & Body | 3 | 03-19-2007 08:42 PM |