|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
11-09-2008, 12:15 AM
|
|||
|
|||
Fuel tap fault
On my 07 ec300 I spent a lot of time trying to get my bike to run on the main jet only to find out that the rubber gaskit in the fuel tap was not cut out correctly in the normal position passage hole. I am aware of another new bike that seized because of this problem. Check your fuel taps. Anyone else struck this?
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| E85 fuel | fkmf6 | General Discussions & Announcements | 29 | 01-20-2014 10:18 AM |
| fuel/oil mix | dareuk | Enduro Engine - 2 stroke | 16 | 05-09-2010 03:46 PM |
| Fuel and AV Gas | kim | Enduro Intake/Carburetion - 2 stroke | 22 | 07-04-2008 11:06 PM |
| Fuel ? | west aussie gas 450 | Australia & New Zealand | 9 | 07-01-2008 04:51 AM |
| Fuel range and fuel light | sanderjavant | Enduro Engine 4 stroke (including EFI & Exhaust) | 6 | 01-05-2008 02:35 AM |
Linear Mode
