|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
another rekluse question
i have fitted the rekluse as per the instructions 8 steel drive plates 7friction plates , and even with the rekluse adjuster turned right in i cannot get an installed gap it just ats like a standard clutch can anyone help please
|
#2
|
||||
|
||||
Back out the adjuster ccw until no tension on screw. Go in with screw cw until you feel slight tension. Turn in screw cw from that point, one full turn plus two marks. Done.
__________________
2011 EC300 Six Days 2010 EC300 Nambotin Replica |
#3
|
||||
|
||||
This assumes you have all the plates correct.
__________________
2011 EC300 Six Days 2010 EC300 Nambotin Replica |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rekluse for my 515 FSE | GasgasTom | Enduro Engine 4 stroke (including EFI & Exhaust) | 7 | 08-27-2023 10:15 PM |
rekluse question | britishgas | Enduro Engine - 2 stroke | 27 | 09-24-2014 05:05 PM |
Rekluse for 02 250 | boostedte37 | "Wanted to Buy" & "Want To Trade" | 0 | 09-29-2013 10:37 AM |
Rekluse Core EXP Install Question | TavisB | Enduro Engine - 2 stroke | 11 | 06-09-2012 06:33 PM |
Rekluse EXP 2.0 for Gas Gas? | AZRickD | General Discussions & Announcements | 13 | 05-25-2011 06:44 AM |