|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ec 300 jetting uk settings
I?ve had a few gas gas 300?s and all run spot on from new so never looked at the carb settings.
I?ve just got myself a toy to green lane on. Ec300 2007-2008 mint but runs shite. Tick over is good. Bottom end pulls well, takes a couple gears to clear when riding at low speed. Somebody has been trying to get thing right the settings are. Main 168 Pilot 38 Slide 7 Needle N1EF top clip. (Lean) AIr screw fully in. Spoke with Kev at gas gas uk He said standerd should be M 178 P 40 S 7 P N1EF middle clip AS 1-1/2 out.. That?s just gonna make it run richer right. Any input would be great on this. I?m a tech rider like it crisp. It’s got an FMF front pipe. If that makes any difference.. Thanks Darren |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Jetting Database - PLEASE ADD YOUR SETTINGS | MattR | Enduro Intake/Carburetion - 2 stroke | 347 | 03-30-2024 09:53 AM |
Apt smart carb settings database, please post your settings | IDAHOSPUD | Enduro Intake/Carburetion - 2 stroke | 8 | 12-13-2013 04:45 AM |
Help... 2012 EC 300 jetting settings... | richardexclaim | Enduro Intake/Carburetion - 2 stroke | 19 | 10-29-2012 07:17 AM |
sag settings.... | BryanMcc | Enduro Suspension | 12 | 09-04-2012 09:04 AM |
JD Jetting settings for linear power delivery? | SpeedyManiac | Enduro Intake/Carburetion - 2 stroke | 5 | 04-06-2010 06:17 PM |