|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
Well I?m going to have to continue this over in the carby section as power valve works fine and I?m pretty sure the sputter up top(in the vid) was running too rich as I was running pj38, mj178 needle n1ef/n3eg clip 2 but when I changed mj to 170 and needle n1ef clip 1 the top end absolutely screams but bottom is worse than puss. Now when it?s in band it just wants to rev forever but before band it?s pretty dead. 1 thing is now it even sounds different since the new stator sounds way more 2stroke tinnie
Thx for all the responses guys, without them I would still be chasing my tail. |
#22
|
||||
|
||||
Congrats on finding the problem.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ec 300 power valve | Jonisaacson17 | Enduro Engine - 2 stroke | 11 | 07-18-2016 09:01 PM |
Power Valve ? | BigAl | Enduro Engine - 2 stroke | 4 | 01-05-2015 09:08 PM |
Loss of power - suspect power valve | Jonny Halls | Enduro Engine - 2 stroke | 4 | 01-22-2013 09:56 AM |
power valve nut | bonkeye | Enduro Engine - 2 stroke | 4 | 10-11-2012 06:40 PM |