|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Installing crank and bearings, best method?
Just tore my 98 ec250 down for a munched crank bearing. As you guys all prob know, splitting the cases took some mallet force. The bearings are tight on crank and case. But they came off crank and were still in the case when finally separated. Just want to know correct procedure for reassembly.
|
#2
|
||||
|
||||
Quote:
__________________
Anders "So you know, that you're over the hill when your mind makes a promise that your body can't fill" (Little Feat: Old Folks Boogie) 2015 EC200 Racing: TE bars, Rekluse Core Exp 3.0, 38mm Lectron & Ohlins S3 steering damper 2006 EC200: 2011 plastics, Rekluse Z-Start, revalved KYB forks & Scotts steering damper 1998 Bimota Supermono 1986 Duc Mille S2 1975 Guzzi sidecar hack 1961 Morini Corsaro 125 etc |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Installing drive-side rear wheel bearings | jdosher | Enduro Chassis & Body | 11 | 12-18-2014 12:08 PM |
08 Crank Bearings | PEB | Enduro Engine - 2 stroke | 17 | 12-04-2012 10:27 PM |
Crank bearings | Marki | Enduro Engine - 2 stroke | 2 | 12-29-2011 11:47 AM |
Crank Bearings? | GasGas | Enduro Engine - 2 stroke | 1 | 07-13-2008 03:24 PM |
crank bearings | steve | Enduro Engine - 2 stroke | 0 | 02-06-2008 02:51 PM |