Motion Pro T3 throttle cable

[gasgasman]

Originally Posted by husley

My 2010 does not have the same carb as pictured....wondering if this cable will work with older style carbs?

Yes, it's the same thread pitch on both carbs.

[gasgasman]

Originally Posted by roverhybrids

So there isn't any issue with the bend in the cable at the top of the carb?
I have one of these cables I was going to swap on and wasn't sure about the bend since the stock cable has the metal tube on the end...

No issues on my bike.

[erniebearskin]

Hi, I am looking at ordering the 5.5" longer KTM T3 cable, but my 2011 EC300 carb doesnt have threads that I can recall. Cable just pops in.

Am I missing something? Will this cable work?

[gasgasman]

The the carb cap has a threaded insert that you remove(brass piece).

The Motion Pro has the threaded end made on to it that screws into the carb cap.

[erniebearskin]

Fuggin A bubba.

Thanks for the quick response.

[gassergrant]

will this fit on a 2003 ec 300 dont trust the cable on it as the clocks slightly kink the cable and hard turn right it revs up a bit

[Simmo737]

I found the t3 has way more free play adjustment than the stock cable and due to the stock cable being (imho) about 1cm too short it was effecting idle at full adjustment. The t3 also seals better on the carb cap.

Since using the t3 I have dropped my pilot and maintain a perfect idle, I could not do this before installing the new cable.

Me happy.

[gasgasman]

Originally Posted by Simmo737

I found the t3 has way more free play adjustment than the stock cable and due to the stock cable being (imho) about 1cm too short it was effecting idle at full adjustment. The t3 also seals better on the carb cap.

Since using the t3 I have dropped my pilot and maintain a perfect idle, I could not do this before installing the new cable.

Me happy.

100% correct!
I noticed the same thing with mine.

[Vindicator]

Anyone knows if the stock 08-11 KTM 300/250 is longer than the GG ? Not Motion Pro one but actual one from KTM.

[mcnut]

I've been running the T3 cables for a while. Make sure you put some silicon on the rubber boot at the carb end. Otherwise the poor fit will allow dirt and water to get in.