Tricks for holding down head o-rings? - Page 2 - Rieju & GasGas Legacy Riders Club Forum

		Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke
Tricks for holding down head o-rings?

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.

Page 2 of 2

#11

05-14-2011, 08:55 AM

GMP

Senior Member

Join Date: Jul 2006

Location: Jefferson Twp., NJ

Posts: 7,597

Nice clean job! Post the final result.

Page 2 of 2

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Head O rings	Highwayman	Enduro Engine - 2 stroke	8	02-04-2010 08:43 PM
Actual size of cyl. Head o-rings?	barbwire44	Enduro Engine - 2 stroke	4	10-11-2009 01:29 AM
Cyl/Head o-rings why so small	Treesmacker	Enduro Engine - 2 stroke	9	02-19-2009 11:09 PM
carb tricks again ....	skid jackson	Enduro Intake/Carburetion - 2 stroke	6	07-25-2008 01:33 AM
Cylinder head o-rings crossover ???	Marcão	Enduro Engine - 2 stroke	5	09-13-2006 08:33 PM

All times are GMT -5. The time now is 04:07 PM.