2011 EC 300 rear wheel

[Gasaholic]

Does anyone know if a rear wheel from a KTM... Yamaha ... Honda... ETC... cross-over to fit a 2011 EC300? I know other parts from other brands cross over , would like to know if a whole wheel assembly would work with maybe just changing spacers. Thanks

[djroggen]

No, why?!? I guess with correct spacers you can make anything kinda fit. There are tons of used GasGas wheels out there, and they nearly all cross.

[bowhunter007]

Don't know if the earlier wheels(pre-07) fit the later chassis. If so, my '00 XC had a 19" MX wheel from a '95 KX 250. It slid right in with the KX spacers, but ultimately wasn't precise enough for me. I know I made shims, but never wrote anything down. When I sold the bike(after a bad crash) I kept the KX wheel, since was part of a set. I do know, on a scale of 1-10, the difficulty level was a 2. It took about an hour to get rideable.

[Gasaholic]

I have not found used wheels .... where can I look ??? Thanks

[djroggen]

2003-11 are the same.

Fire1998 had a part out $100 each for Did u shaped rims, maybe he still has them? If I needed them I would buy both front and rear. Dang he sold them already.... But keep eyes open for part outs.

[Gasaholic]

OK, I'll keep looking...Thanks

[Punk]

I've put the rear wheel off of my 1985 KDX 250 on . If you grind the one spool slightly it is a pretty good fit . So KDX 200 may be the same and maybe KX 250 possibly . Punk