|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Removing electric start
I have a 2011 250 that I haven't used electric start since I purchased it in 2012. I would prefer to clean up the look and lose the added weight. Anybody already done this? Thanks in advance for any advice and specific instructions.
|
#2
|
||||
|
||||
You would need the non e-start ignition cover. If you wanted to simplify the wiring, it would be best to do a swap with someone who wants an e-start and trade them your sub frame and wiring harness, which is what I did to gain my e-start. But to remove just the starting apparatus only requires replacing the ignition cover with a non e-start cover.
__________________
Phil (New bike pending...) |
#3
|
|||
|
|||
Quote:
|
#4
|
|||
|
|||
bringing this post back from the dead, but any chance you still have all of the e start components you took off the bike? I have a non e start bike I would be interested in converting
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2012 300 Electric Start | Brecht803 | Used Bikes | 4 | 07-27-2015 05:16 PM |
Will there be an electric start for 2012 | nmrider | General Discussions & Announcements | 5 | 09-19-2011 03:04 PM |
New 2011 Gas Gas EC 300 (Electric Start) | onegreyghost | General Discussions & Announcements | 32 | 08-31-2010 07:23 PM |
electric start 2 Banger Gas Gas | Klausen | Enduro Engine - 2 stroke | 1 | 06-21-2010 06:19 PM |
Electric Start EC300 | J D | General Discussions & Announcements | 25 | 02-22-2010 03:12 PM |