|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
idling problem
Any ideas as to why my ec 300 wont idle very well after its had a little throttle and is then left to idle?
|
#2
|
|||
|
|||
Most likely jetting. Air screw, pilot jet and needle are the usual suspects.
However, before you tweak jetting, check your spark plug to see if it is fouled.
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
#3
|
||||
|
||||
I never got my 300 to provide a stable idle despite trying all sorts of jetting. I could get it to idle for a minute max. Rumour has it you need a leaner slide on some.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EC 300 problem!!!!!!!! | clerky clerk | Enduro Engine - 2 stroke | 31 | 07-06-2011 05:19 PM |
And then this became a problem. | dank | Enduro Engine - 2 stroke | 9 | 03-22-2010 07:58 AM |
50 boy problem | Sharpie | Mini Gasser 's Corner | 3 | 09-04-2008 03:58 AM |
07 FSR 450 injector problem? | GavGav | Enduro Engine 4 stroke (including EFI & Exhaust) | 14 | 03-10-2008 05:51 AM |
I think I have a problem | SpeedyManiac | General Discussions & Announcements | 7 | 11-30-2007 11:26 PM |