2010 EC300 Factory Jetting Specs - WTF?

[motogroove]

Originally Posted by Jakobi

You're half a clip richer than I am now with my current setup (N3CH) and I think I could go half a clip leaner on the needle. A full clip was too much and I fell flat and got some pinging

OK... I'm trying to learn here...
how do you go "half a clip"?

[Bailey28]

You can get tiny .5mm washers from the local hobby shop... For example, if you want clip 2.5 instead of 2, stack a .5mm washer under the E clip and it will raise it the 1/2 clip distance. A full clip is 0.9mm from one to the next.

I know .5 and .5 is 1.0, but this .5 is close enough.

[motogroove]

Originally Posted by Bailey28

You can get tiny .5mm washers from the local hobby shop... For example, if you want clip 2.5 instead of 2, stack a .5mm washer under the E clip and it will raise it the 1/2 clip distance. A full clip is 0.9mm from one to the next.

I know .5 and .5 is 1.0, but this .5 is close enough.

Cool Thanks.

[Jakobi]

Originally Posted by motogroove

Cool Thanks.

or.. the more permanent and correct way is to buy the needle that is half a clip leaner :P

In this instance, i am using N3CH on #2. Half a clip leaner is N3EH on #1.

[husley]

I think I have found the set-up I am happy with:

2010 300
4000-7000'
50-80' F

38, N3CH #2, 175

Tried this set up for the first time earlier in the week, works just fine. I think I could go just a little leaner on the clip, but it is close enough fore me

J

[Jakobi]

Originally Posted by husley

I think I have found the set-up I am happy with:

2010 300
4000-7000'
50-80' F

38, N3CH #2, 175

Tried this set up for the first time earlier in the week, works just fine. I think I could go just a little leaner on the clip, but it is close enough fore me

J

This is my base setting. I am running a 178 just to be safe as im in the cooler months. Will all change when I get the new head maybe. Time will tell.

If you could get your hands on a N3EH and try pos one it might be just what the needle is asking for.

[husley]

Originally Posted by Jakobi

This is my base setting. I am running a 178 just to be safe as im in the cooler months. Will all change when I get the new head maybe. Time will tell.

If you could get your hands on a N3EH and try pos one it might be just what the needle is asking for.

I will be going back to a 178 when it cools down, or maybe 40/180 when it gets really cold.

By mistake I purchased a N3EG thinking it was a N3EH....... I dont think I will monkey with it..........but I change my mind often so you never know.

Thanks to the folks on this site/thread that helped me get to these settings as I am new to the GG world

[Bailey28]

For Jakobi:


N3CH vs. N3EH. Very little difference here.