|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Float valve.
Hello,
Two bikes 2006 EC 300 and 2014 EC 250. Does anyone know if the float valves are the same in the round top carb and the AS2 ? Cheers Bill |
#2
|
|||
|
|||
Nope, screwtop has deeper float bowl. Height should be 16 mm, I believe, or seam parallel with bottom of carb body. Short body carb height is approximately 6mm, most run a tad lower, I run mine at 7.5mm.
|
#3
|
|||
|
|||
Thanks for the reply but I mean are the actual valves the same.
i.e the part that shuts off the fuel. Cheers Bill |
#4
|
||||
|
||||
According to Jets-R-Us all dirt bike PWK's from 33mm to 41mm share the same float. https://www.jetsrus.com/carburetor/a...selection.html
__________________
WildAzzRacing YouTube channel Trail Riders of Southern AZ club AZ State Parks OHV Ambassador '11 EC250R '98 KDX220 |
#5
|
|||
|
|||
Hello,
Thanks for that . Cheers Bill |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
float level | masterbill | Enduro Intake/Carburetion - 2 stroke | 0 | 04-01-2020 05:32 AM |
Float valve seat removal...? | Davehuge | Enduro Intake/Carburetion - 2 stroke | 19 | 09-29-2017 04:45 PM |
How to set float | rzide | Enduro Engine - 2 stroke | 3 | 01-22-2014 10:51 PM |
Float Fix | gasser | Enduro Intake/Carburetion - 2 stroke | 1 | 03-29-2009 10:32 AM |
KEIHIN float valve | nhrider | Enduro Intake/Carburetion - 2 stroke | 1 | 06-17-2008 01:10 PM |