|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
01 gasgas 250 ec jetting help
I have 01 gasgas 250 ec. I ride at around 1,500 feet ruffly. With 50:1 93 octane mix gas . It used to be 32 :1 and I want to change it to 50:1. The needle that was in it before was nozf with a 38 pilot and I could not read the other number for main jet. I have a needle laying around n1ef idk if it good for my bike or what jets to use with that needle . I just need some advise on what jet to go with the n1ef needle with 93 octane fuel 50:1 br8eg plug 1,500 feet
|
#2
|
|||
|
|||
have a look in the local jetting database.
look for the same bike, same altitude and se what they did and rear the comments on their setting. http://www.gasgasrider.org/forum/sho...tting+database |
#3
|
||||
|
||||
According to older posts the n1ef is similar to a n1eg which works very well for GG bikes. You will find lots of info on both needles.
|
#4
|
||||
|
||||
I have had gasgas sense 1998 we always run ltr needle which is a ddk needle worked great in a air Stryker 1 round top 172 Maine 42 pilot ddk needle 2 nod from top it will rip
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
GasGas factory, why terrible jetting? | Davehuge | Enduro Intake/Carburetion - 2 stroke | 11 | 06-23-2019 07:42 AM |
2011 GasGas EC 300 Jetting baseline | Neels | Enduro Intake/Carburetion - 2 stroke | 4 | 11-24-2018 02:16 PM |
GasGas ec250 2013 jetting? | 28gasser250 | Enduro Intake/Carburetion - 2 stroke | 5 | 01-05-2014 06:16 PM |
Jetting (needles) 2013 gasgas ec 250 | nickp | Enduro Intake/Carburetion - 2 stroke | 7 | 11-03-2013 02:25 PM |
JD Jetting KTM/GasGas | fixmare | Enduro Intake/Carburetion - 2 stroke | 3 | 08-09-2012 06:03 AM |