|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cylinder o ring groove depth
Can anyone confirm the depth and width of cylinder o ring grooves? Need accurate measurements as want to use o rings to convert a non o ring engine.
Cheers andy |
#2
|
|||
|
|||
http://www.athenaparts.com/eng/model...gas-gas-ec-300
Personally i would go 1mm deep. They sit proud and stay in which means it's past the half way point of the o-ring
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
#3
|
|||
|
|||
I have bought these size orings for my ec300
out 107.67x1.78 Int 75.92x1.7 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cylinder head o-ring size?! | adriano.ro | Enduro Engine - 2 stroke | 2 | 01-12-2017 02:40 AM |
Wanted: Piston/Ring, Cylinder Bore, Plastics for 2000 EC200 | flatout111 | "Wanted to Buy" & "Want To Trade" | 0 | 05-12-2013 05:34 PM |
Cylinder head o-ring crossover | Metalefty | Enduro Engine - 2 stroke | 0 | 03-18-2012 11:09 PM |
Setting the res piston depth ??? | moto9 | Enduro Suspension | 4 | 01-25-2012 03:00 PM |
Cylinder head o-ring question | Cruiser | Enduro Engine - 2 stroke | 4 | 04-14-2011 08:58 AM |