|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
cylinder crack, do you think this could be repaired?
Can I have your opinion on this cylinder please, do you think this could be repaired or is it scrap?
Cheers, RJ. |
#2
|
||||
|
||||
I would presume it to repairable, but the best answer would be from Langcourt or the like. I would give them a call and worst case is you are out the cost of shipping with a good and reliable response.
May I ask what year, displacement, and how many hours, if known? Any symptoms or was this a discovery during service?
__________________
Phil (New bike pending...) |
#3
|
|||
|
|||
I would say not personally. The crack looks like it started at the exhaust port and spread upwards, meaning there's a fair chance it's cracked down the exhaust port too. To be honest, it'll make a great paper weight, just bid assuming that your just buying a head, and hope you get it cheap enough.
It's an EC300 cylinder. |
#4
|
|||
|
|||
Is that your cylinder WAZ?
|
#5
|
||||
|
||||
The cylinder replating places weld that stuff up all the time.
Should not be a problem to have it done. |
#6
|
||||
|
||||
http://www.powersealusa.com/
https://www.mt-llc.com/ http://www.maxrpms.com/free-cylinder...inder-plating/ Reach out to these guys and see what they say. I would bet it can be fixed.
__________________
15 Beta 300RR Race Sold KTM 450EXC now moving over to RED! Looks like I found the right bike. Thanks REVERUP! 2011 GasGas EC300 "Stolen By A Scum Bag" 2009 450EXC Sold to Rapid Dog EURO Factory Anti-Hop slipper clutch, GPR V4, Akropovic Full Ti Exhaust, 2013 suspension and wheels. 2009 300XC 2005 525 MXC 2000 WR 400 1996 XR 600 1987 CR500 1990 KX500 |
#7
|
|||
|
|||
No mate, I was talking to the guy that's selling it. I was going to bid because I wanted a spare head to modify, but bought one elsewhere. You can buy a bare cylinder for about ?270, by the time you've bought that one, had it welded and replated (including vat and postage), it'll probably owe you ?200+. For me that isn't enough of a saving to bother with.
If you do buy it, let us know how you get on. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
small crack in case | msd808 | Enduro Engine - 2 stroke | 11 | 04-19-2012 12:43 AM |