|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Flashing lights!
When I rev the engine the lights flash. Any idea's?
__________________
2005 EC 200 |
#2
|
||||
|
||||
flashing
All the lights? Or just headlight? If just headlight, check the bulb. Maybe a loose connection that comes/goes with engine vibes.
__________________
2012 xc300 - Great bike! sold looking for 18+ |
#3
|
||||
|
||||
Front and rear come on and flash when revved!
__________________
2005 EC 200 |
#4
|
||||
|
||||
If they worked fine before you need to recheck all connections for a loose fit. Also check where the ground bolts to the frame by the ignition coil. That could possibly be loose.
__________________
-Mike 2009 Beta Evo 300 4T - 1982 Suzuki PE175 |
#5
|
|||
|
|||
On my 2013 300, under the headlight fairing were the male/female spade connectors for the headlight circuit. The plastic covering for these connectors are supposed to mate over one another to cover the conductors. On my bike they used the same covering on both sides so that they wouldn't mate, hence the conductors could short and cause the light to flash.
Great bike, but gee, the attention to detail in some areas is slack! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How can i turn my lights off | nickp | General Discussions & Announcements | 2 | 10-28-2012 07:56 PM |
lights flickering and going off when revved | Elliker | Enduro Engine - 2 stroke | 9 | 01-21-2009 05:28 PM |
Night Riding Lights | Steveo | Enduro Electrical & Wiring | 12 | 12-12-2008 07:39 AM |
No lights after engine assembling | Leon_gasgas | Enduro Electrical & Wiring | 1 | 08-15-2006 02:50 AM |