|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Wrist pin snap rings
I searched previous threads but I saw nothing,I'm doing my top end with a Vertex kit.Is there a good method of putting in those RUGGED snap rings???? I tried but I scratched the piston near the clip groove ! And will that hurt anything else? Thanks!!!!!!!!!
|
#2
|
|||
|
|||
They are the hardest circlips I have ever used! It was a pain getting them in.
I was told you could use clips for a CR250. |
#3
|
||||
|
||||
|
#4
|
||||
|
||||
Glenn,
How do you find all of this stuff? This think looks really cool, and will buy one if you provide a favorable report. Thanks. That might be a great find. blitz |
#5
|
|||
|
|||
trim
I cut about 3 mm off each clip,ground off the rough burrs,they went in hard but were managable.Wich tells me I did not compromise strength just a little clip length. Oh yea,I made sure they did'nt fall short off the groove to get them out.I'll give feed back if they dislodge,wich I dought.
|
#6
|
||||
|
||||
I don't like that idea, hope you have enough tension.
blitz, I heard about it some time ago. Since I'm doing the top end soon I did a search and it popped up. End of the month I'm pulling mine down and will shoot pics and review. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wrist Pin Bearing | SpeedyManiac | Enduro Engine - 2 stroke | 16 | 10-08-2009 09:37 PM |
wrist problems | gascanuck | Injury & Recovery | 16 | 03-17-2009 07:49 AM |
2001 300 EC - More Snap Needed | krazy | Enduro Engine - 2 stroke | 12 | 09-13-2008 09:50 PM |
Wrist-pin retention clips | FFRDave | Enduro Engine - 2 stroke | 10 | 01-18-2008 09:53 AM |
Wrist Pain & Thumb Throttle Question | RPB111 | Injury & Recovery | 8 | 10-22-2007 05:55 PM |