|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Wrist pin snap rings
I searched previous threads but I saw nothing,I'm doing my top end with a Vertex kit.Is there a good method of putting in those RUGGED snap rings???? I tried but I scratched the piston near the clip groove ! And will that hurt anything else? Thanks!!!!!!!!!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wrist Pin Bearing | SpeedyManiac | Enduro Engine - 2 stroke | 16 | 10-08-2009 09:37 PM |
wrist problems | gascanuck | Injury & Recovery | 16 | 03-17-2009 07:49 AM |
2001 300 EC - More Snap Needed | krazy | Enduro Engine - 2 stroke | 12 | 09-13-2008 09:50 PM |
Wrist-pin retention clips | FFRDave | Enduro Engine - 2 stroke | 10 | 01-18-2008 09:53 AM |
Wrist Pain & Thumb Throttle Question | RPB111 | Injury & Recovery | 8 | 10-22-2007 05:55 PM |