|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
04-02-2012, 06:22 PM
|
||||
|
||||
Rod Interchange ???
Okay I know i've seen it before but my search has come up with no definitive answer. Does the 84-01 cr250 rod interchange with the gasgas 300 since my engines mostly apart I figured i'd rebuild the whole thing.since its 10 years old i think a fresh bottom end might last me forever.
So does anyone know for a fact? not a guess or rumor that the cr rod works? thanks for any info Stoby Also how about bottom end bearing options $90+ for one bearing seems $$$$$$$$$$$$$$$$$ Any info on that i didnt search it Thanks again Last edited by Stoby; 04-02-2012 at 06:27 PM. Reason: forgot something 
|
|
#2
04-02-2012, 06:49 PM
|
||||
|
||||
|
cr rod works, just did it a month or 2 ago.
bearings, c3, open 6206 63/28
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 125 Parts Interchange | orangezuk | General Discussions & Announcements | 4 | 03-18-2011 10:43 AM |
| fork interchange | Bailey28 | Enduro Suspension | 11 | 03-03-2011 08:34 AM |
| Pampera 280 interchange | Senior29 | Enduro Chassis & Body | 4 | 02-26-2011 03:18 PM |
| 07 300 pipe interchange | (F5) | Enduro Engine - 2 stroke | 6 | 02-16-2011 03:59 PM |
| SWingarm Interchange | PEB | Enduro Chassis & Body | 1 | 01-12-2011 03:34 AM |
Linear Mode
