|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
countershart sproket spoogle...
recently looking at my bike, have not been ridding for about 6 months, and looking my bike over, noticed a lot of oil under and around the area, i dont think it is just chain lube.
so, the question, what is the o-ring called? i mean the part number, and such. also how often should this be replaced? thanks, alex. |
#2
|
|||
|
|||
There is a special shaft seal and (2) 25x2 o-rings.
Check out the parts manuals for the part numbers... http://www.gasgasmotos.es/eng/frame.htm Go to user manual, then part list. When they start leaking excessively it is time to change them. I grease my countershaft to prevent rust, which can really impair seal replacement.
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
14 front sproket | gg3 | Enduro Chassis & Body | 13 | 09-26-2010 12:19 AM |