|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Nikasil plating
Can anyone from the uk please reccomend a good place (possibly lincolnshire) to get my barrel done thanks luke
|
#2
|
||||
|
||||
nikasil replating
Quote:
How about BDK engineering which is based in norfolk Try Graham File who has now taken over some of stan stephens tuning and services Motrac racing |
#3
|
|||
|
|||
Thanks for that I have been in contact with langcourt and it is going to cost me 200 quid for a couple of noggins missing round the ports welded and re bored then nikasil plated.. Does this sound about the right price? Also how much are new barrels?
|
#4
|
|||
|
|||
Quote:
i paid about 300 pounds just for plating, but then again, it did get shipped from belgium to the gassers factory in spain!! |
#5
|
||||
|
||||
Quote:
If I recall you were looking for another engine at one point Have a look on ebay germany I've seen a 300cc barrel conversion http://www.ebay.de/itm/DEMO-Zylinder...item3a62e0077f |
#6
|
||||
|
||||
|
#7
|
|||
|
|||
Barrel should be back from langcourt tomorrow
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Millenium Tech Cylinder Plating Review | Stoby | Enduro Product Reviews | 16 | 11-18-2011 07:51 PM |
nikasil & piston | Stoby | Enduro Engine - 2 stroke | 5 | 07-07-2011 10:33 PM |
Plating (license, not chrome) Thread | twowheels | Suggestion Box | 5 | 09-06-2010 03:43 PM |