|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
VForce 3 reed wear
I pulled my reed valves to check them on my 11 EC300 - 60 hours ( trail ride speed mostly) . They all look good except the lower reed I could see a lot of light through the petal itself ( not the edges sealing to the frame ) when I held a flash light to it. It felt fine. Its surfaces felt the same and still seemed as stiff as the others. Is this an issue?
Thanks for any input. |
#2
|
||||
|
||||
Quote:
Are they closing completely? Meaning sealing on all 3 sides? No chipped or frayed edges? They are pretty thin and carbon so it would seem to make sense that a bright lite would some what shine through them. I'd say there fine as long as no chips on the edges.
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals |
#3
|
|||
|
|||
I had the Problem with the vforce that they are sealed in the front but not on the sides also with new reeds. I switched back to boyesen reed cage and now the bike is working good.
__________________
4 strokes are only good for power generators |
#4
|
|||
|
|||
thanks for ithe nput
The reeds do seal along the edges nicely. They all seemed to have a good seal and snap back in place. The only concern was one petal allowed light through.
|
#5
|
|||
|
|||
If light comes through, it is not sealed!!!
__________________
4 strokes are only good for power generators |
#6
|
|||
|
|||
light
ok to be clear, the light is NOT coming through were the reed petal contacts the frame. is through the entire petal. Like the carbon fibre weave is more widley spaced.
|
#7
|
|||
|
|||
Should be no problem, as long the petal is not broken
__________________
4 strokes are only good for power generators |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
vforce replacement reed part number? | stainlesscycle | Enduro Intake/Carburetion - 2 stroke | 0 | 10-24-2012 04:45 AM |
More oil = less wear | Eric K | Enduro Engine - 2 stroke | 16 | 01-31-2010 05:49 AM |
Replacement Vforce reed petals? Part # | joey11 | Enduro Intake/Carburetion - 2 stroke | 1 | 02-10-2009 05:28 PM |
Vforce for 200ec | RayGas | Enduro Intake/Carburetion - 2 stroke | 1 | 01-14-2008 04:03 PM |