Oversized discs for supermoto gas gas Wheels?

[johns2394]

Oversized discs for supermoto gas gas Wheels? can they be bought where to get them from are the supermoto hubs same as offroad ones

[slocalspode]

You might try here first:
http://www.moto-master.com/default.php
search by bike name. There is a USA
dealer, if you are in the States.
You might look up motostrano.com and
give them a call.
GoFasters may also be able to get you
a real GasGas brand front rotor as well
as a caliper relocation bracket.
As far as I know. The SuperMoto wheel
hubs are the same as Enduro wheel hubs.
If you have not found it yet. Supermotojunkie.com
has lots of general SuperMoto information.
Not a lot on GasGas though.
Here is my set up for a 1998 EC250SM with the
Marzocchi 50mm forks and Brembo caliper.

Yours is most likely going to be different.
Good luck, Jeff

[johns2394]

still struggling with finding a rotor and bracket or any UK place that i can get these from what about genuine gas gas parts any help please

[cal_tony]

I previously posted about my inability to find Supermoto wheels and brakes for my 450FSE. I ended up by going with a 17" KTM front wheel, hub and rotor. For the rear, I went with DRZ stuff. Parts for this setup are available anywhere.

For a front bracket to mount the rotor,I took Jeffs advice and bought a Motomaster bracket so I could mount a 320mm rotor to the front fork.

Tony

[cookeye]

On my 2002 ec i used a ccm 320mm front disc listed for most of the supermoto ccm's including the 404, my 404 had WP forks the same calliper braket as my 2002 ktm and same as my 04 404 ccm, this allso bolted up to my gasser
hth
mick

[johns2394]

does the ccm disc fit the gas gas wheels then or did you just use the ccm adapter bracket