2 small "cup" washers in linkage?

[r00zter]

Ok...first off...thanks for the questions answered in my two earlier posts. Now....I was assembling the linkage/suspension today and ended up with 2 small "cup" shaped washers that I don't remember where they go. The bike has been apart for like 2 months (1st gasgas), and I'm just now getting back to putting it together. Any idea where the go and what direction does the concave/convex point? Thanks. 2011 EC 300

[lonetree]

over the bottom shock bearing, they act as a "seal". should be an oring underneath...

[r00zter]

Ah ok thanks. So do they go like (I I) or like )I I( against the bottom of the shock? I already installed them like (I I) since it seemed like it kinda pressed against the O-ring to secure it. Hope thats correct.

[lonetree]

yep, your right, good to go.