|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2015 ec250 pv nut/cover loose
hi guys i went to remove the 27mm nut that covers the power valve adjust and it just spins. The treaded part in the engine case moves with the nut. Does anyone know if it has a securing nut on the inside or it should be a press fit and not move? cheers
|
#2
|
||||
|
||||
The male threaded insert is press fitted and held in with Loctite.
From the cut away view, looks like it just slides out. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2015 ec250 interchangeable radiator braces/guards | ljdb | Enduro Engine - 2 stroke | 2 | 07-02-2017 12:46 AM |
New to gasgas. Just purchased 2015 ec250 | ljdb | General Discussions & Announcements | 16 | 06-30-2017 06:56 AM |
Any ideas on 2015 EC250 jetting? | MOGaser | Enduro Intake/Carburetion - 2 stroke | 2 | 12-20-2014 06:40 PM |
ec250 stator unit 5 of the 8 coils are burnt and loose | KTMAndy | Enduro Electrical & Wiring | 0 | 10-19-2013 03:18 PM |