|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Quote:
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#12
|
|||
|
|||
top bearing first, then pinion? paranoid that the gears won't catch properly... been a fiasco up til now.
|
#13
|
||||
|
||||
Quote:
https://thumpertalk.com/forums/topic...ge/4/#comments Quote: If you want to check to see if that screw did back off you'd have to drill a hole behind the case. There should be a decent gap of a couple mm between screw and case. It's easy enough to seal up the hole with jb weld when the case is off the bike. Use painters tape around the hole in the shape you want and you can peel while jb is still wet for a clean look. It's also very difficult to see the jb weld when the case is back on. The grey on black is the jb weld on my case while on the bike.
__________________
'18 GG XC 300 '05 GG DE 300 '01 GG txt 321 |
#14
|
|||
|
|||
Great, thanks Jeff!
|
#15
|
||||
|
||||
Quote:
Put the long shaft with the small bearing and screw (loctited) in first, then tap the pinion with the larger bearing in place carefully checking free play in multiple points until happy. Seat circlip and recheck. Should all spin by finger very easily.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#16
|
|||
|
|||
Sounds good Nate, appreciate your time and advice.
|
#17
|
||||
|
||||
All good mate, glad to help a fellow gasser get the starting system like I know it should work. Knock on wood mine has been faultless hot or cold since new and it has about 2500k and 160 hours.
I would definitely think about sealing the whole system up and running it wet with a breather. Plenty of threads on that. Everything spins up easier and is always well lubricated.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2005 EC300 Kick Start spline/shaft | icebergstu | Enduro Engine - 2 stroke | 2 | 03-08-2019 01:46 AM |
kick start shaft | dANbOT | Enduro Engine - 2 stroke | 11 | 09-07-2015 11:20 AM |
E start removal | erniebearskin | Enduro Electrical & Wiring | 5 | 02-14-2013 08:45 PM |
Balance shaft removal. | darren | Enduro Engine - 2 stroke | 3 | 11-15-2009 05:18 PM |