|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
They don't work, too humid here.
|
#12
|
||||
|
||||
Ktm had a simular problem on some of their bikes...the fix was the weld the back side of the pin so it wouldn't fall out and get lost in the bottom half of the motor.
|
#13
|
||||
|
||||
I remember seeing those when I got my '09 300xcw. My pin was welded on the back, just looked either like it didn't get any penetration into the pin itself from the back, or the pin had a casting issue because it looks like it has a bubble in the middle. A buddy of mine used a little more CO2 and got some deeper penetration this time
__________________
Rob Granger / Katy, TX EC300 Breaking more things by 8:00AM than most people break all day. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
200 Jetting, help me sort this thing | noobi | Enduro Intake/Carburetion - 2 stroke | 20 | 03-27-2012 03:39 PM |
and then this thing broke.... | dank | Enduro Intake/Carburetion - 2 stroke | 2 | 03-21-2010 05:18 PM |
EC300 + force rad guards, wtf is this thing? | gearb0x | Enduro Chassis & Body | 7 | 11-08-2008 09:03 AM |
It doesn't fit.... | stay_upright | General Discussions & Announcements | 7 | 03-04-2008 12:55 PM |
A funny little thing... | FFRDave | Enduro Suspension | 3 | 09-23-2006 05:15 PM |