|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
GAS GAS EC250 2011 Base cylinder gasket
Hello everyone
I just got a new piston for my GAS GAS EC 250 2011 and the new gaskets. In the package there are two base cylinder gaskets. One is thicker than the other. Which one should I use? |
#2
|
|||
|
|||
easy answer, compare to the old one. More technical, do a search for "base". Tons of threads on this subject.
__________________
jeff '00 XC250 (mine) LTS front and rear suspension, power valve cover, carb jet kit and rear chain glide, RB Designs head mod, BRP tall triple clamp, backyard foot-peg lowering conversion. '04 EC250 (the kids) (he can do his own mods haha!) |
#3
|
||||
|
||||
I used both on my 11 300. I really liked the way it ran after that.
__________________
2013 GasGas 300 2004 GasGas 200 2011 GasGas 300 Ortonville Minnesota |
#4
|
||||
|
||||
Some people like going thinner, to reduce the squish and raise compression. Note that the 0.004 super thin one is a shim that is not a gasket.
|
#5
|
|||
|
|||
Is that the transparent plastic one that comes in the Athena kits?
|
#6
|
|||
|
|||
Thats the gasket kit that I got. Is that plastix useful?
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Base gasket 2011 EC300 | Quigs | Enduro Engine - 2 stroke | 10 | 10-04-2015 04:58 PM |
wet base gasket | thejackrabbit | Enduro Engine - 2 stroke | 6 | 02-09-2014 01:03 PM |
Base Gasket re-use? | motogroove | Enduro Engine - 2 stroke | 5 | 06-26-2011 07:56 PM |
2010 300 Cylinder Base Gasket Question | coopernicus | Enduro Engine - 2 stroke | 12 | 06-22-2011 09:31 PM |
Base gasket | Ud_luz | Enduro Engine - 2 stroke | 21 | 05-09-2008 07:38 AM |