|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
|
Thread Tools | Display Modes |
|
#1
04-11-2016, 05:47 PM
|
||||
|
||||
2011 ec125 Six Days [Jetting]
What have you guys been running for jetting on a 2011 ec125. This is a new six days that has a ASII 38mm carb on it. Jetting on it right now is
170 main 40 pilot n3cw needle 2nd clip position 1.5 air screw Bike starts and idles good. Takes off and feels good at low rpm. If you get into the throttle it starts to die out real bad like its real lean in the mid. Seems to run good on the top end once you get it there. This is about the same jetting that I have been running in the 250's and 300's with good luck. Does the 125 require totally different jetting? elevation about 4,000 ft. air temp=65'F. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2011 EC125 Six Days parts on E-Bay | nknudsen | Parts | 5 | 10-17-2014 04:06 PM |
| EC125 - base line jetting | doutsh | Enduro Intake/Carburetion - 2 stroke | 9 | 09-08-2014 12:11 PM |
| Jetting help 2011 six days 300ec | Colemanian | Enduro Intake/Carburetion - 2 stroke | 9 | 11-14-2012 09:52 PM |
| 2011 125 6 days jetting | orangezuk | Enduro Intake/Carburetion - 2 stroke | 11 | 04-28-2011 11:09 PM |
| jetting for ec250 2011 six days | taku60 | Enduro Intake/Carburetion - 2 stroke | 2 | 02-01-2011 11:01 PM |
Threaded Mode