|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#11
01-28-2023, 10:54 PM
|
||||
|
||||
If the bearing was bad I would expect you could move the clutch up and down or front to rear.
If you do the work yourself it will only cost you the bearing(s) and a set of gaskets. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2011 ec250 engine complete low hours | roverhybrids | Parts | 8 | 04-24-2019 06:10 PM |
| Engine/Gearbox Noise? | nato | Enduro Engine - 2 stroke | 5 | 05-04-2015 06:17 AM |
| Engine noise when idle | Sjohan | Enduro Engine - 2 stroke | 15 | 04-30-2015 09:24 PM |
| 2011 ec250 engine complete 70hrs | roverhybrids | Parts | 3 | 01-16-2014 08:20 PM |
| Engine noise | roostafish | General Discussions & Announcements | 11 | 11-24-2009 12:01 PM |
Threaded Mode