|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
EC 250 clutch problem
Well after looking at the posts on here....
My clutch was in bad need of replacement....dragging BAD....from the PO.... I put a 95ish CR250 clutch in and stood it back up and the clutch feels like a brake....so I took the metals out and used the originals and it still felt like thatbut worked(a very little)..... so what is the cure.... little baffled....I read about a different washer but dont really understand what and where it goes.... |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
450 Clutch problem | trxpeter | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 09-03-2010 12:38 AM |
Clutch problem sticky? | dank | General Discussions & Announcements | 16 | 05-26-2010 01:20 PM |
also an ongoing clutch problem...... | dank | Enduro Engine - 2 stroke | 2 | 05-19-2010 01:24 PM |
ec300 clutch problem | dirtjunky_uk | Enduro Engine - 2 stroke | 13 | 02-27-2009 08:08 AM |
450 Clutch problem | mike989 | Enduro Engine 4 stroke (including EFI & Exhaust) | 17 | 01-02-2008 08:54 AM |