|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
01-11-2008, 10:27 PM
|
|||
|
|||
Wrist-pin retention clips
I deformed one during instalation.
It is for a Vertex 300 piston. I gather that the wrist pin and clips are not part of the Vertex piston kit. ME25616035 is the "ROD.RV.18X22X21,8 S E-416" I think this is the wrist pin and clips. I only need one of the clips. I noticed that those clips for the 300 cc piston are much much more stout than what I am used to on the 250s. If anyone has one of these laying around in good shape, I could make good use of one. Can the deformed one be bent back into shape ?
__________________
ONCE Y0U GO GAS GAS, YOU NEVER GO BACK !! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wrist Pin Bearing | SpeedyManiac | Enduro Engine - 2 stroke | 16 | 10-08-2009 09:37 PM |
| wrist problems | gascanuck | Injury & Recovery | 16 | 03-17-2009 07:49 AM |
| Wrist pin snap rings | steve | Enduro Engine - 2 stroke | 9 | 04-08-2008 08:19 AM |
| Wrist Pain & Thumb Throttle Question | RPB111 | Injury & Recovery | 8 | 10-22-2007 05:55 PM |
| Fuel Pump Clips Broken | KTMrider58 | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 04-15-2007 04:18 PM |
Threaded Mode