|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
10-01-2009, 08:08 PM
|
||||
|
||||
Wrist Pin Bearing
Hi guys,
Need answers quick. I'm rebuilding the top end in my bike after it siezed last weekend (ring pin failed, ring rotated and then got caught in the exhaust port....ouch). I forgot to order a new wrist pin bearing to install, so I need to know (1) how much play is acceptable in this bearing and (2) will a Honda CR250 wrist pin bearing fit (which year?)? Let me know ASAP. Thanks, Steve 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Big End Bearing | twistywizard | Enduro Engine - 2 stroke | 15 | 01-26-2011 06:33 PM |
| wrist problems | gascanuck | Injury & Recovery | 16 | 03-17-2009 07:49 AM |
| Wrist pin snap rings | steve | Enduro Engine - 2 stroke | 9 | 04-08-2008 08:19 AM |
| Wrist-pin retention clips | FFRDave | Enduro Engine - 2 stroke | 10 | 01-18-2008 09:53 AM |
| Wrist Pain & Thumb Throttle Question | RPB111 | Injury & Recovery | 8 | 10-22-2007 05:55 PM |
Threaded Mode