|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
02-27-2012, 08:23 PM
|
|||
|
|||
clutch question
hey guys just been stripping my clutch and noticed one of the padded parts broken (friction plate is it?) its the one that sits at the rear of the clutch stack (closest to main crank case) is this a major/common problem? also it seems thinner than the others.. mabye this is why its snapped.. its off my ec250 its a 2000 model but has a counterbalance shaft in it so not sure which set to order??? if i need to order a new set??? any help welcome cheers luke
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| clutch assy question | Moto-x | Enduro Engine - 2 stroke | 2 | 01-25-2012 11:32 AM |
| FSE 400 clutch Question | Gerko | Enduro Engine 4 stroke (including EFI & Exhaust) | 0 | 02-01-2011 06:20 AM |
| Clutch question. | darren | Enduro Engine - 2 stroke | 5 | 09-23-2010 09:16 AM |
| KTM 50 Clutch Question... | tprnottp | All Other Bikes... | 8 | 09-28-2008 11:17 PM |
| FSE Clutch Question | mike989 | Enduro Engine 4 stroke (including EFI & Exhaust) | 2 | 09-24-2007 07:29 AM |
Linear Mode
