|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Part left over!
Uh oh!
I have finally got to the point of reassembling my 1998 EC250 engine having changed all the bearings, seals, dogs, and a host of other little bits. I'm just about to fit the clutch and found that I have two thrust washers I've measured them and they are identical. Does anyone have an idea of where the spare one should have been fitted? I shouldn't laugh but I can't help it. |
#2
|
||||
|
||||
there are 2 thrust washers behind the clutch... check the fiche to see (1 behind hub, and 1 behind basket)- what are the dimensions of the washers?
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#3
|
|||
|
|||
Thanks for that, I've only just noticed they have the same part number. The fiche is not the best quality but it is free. Size is identical. I remember the thickness is 2.8mm.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
03 gone,, only my 97 left,, | Cruiser | General Discussions & Announcements | 6 | 04-17-2008 07:01 PM |