|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Anything will be fine. Stay away from castor based oils. I like Klotz R50 because it smells good. So if you are going to ride in front of me, can I put in my request?
__________________
Mike Sheetz OMRA #21AA What will I be riding next? Christini GG 300? '15 KTM 300 XC-W '08 EC 250 (Gone to new happy owner) Gran Prix Cycle LTR Suspension RB-Designs |
#12
|
||||
|
||||
Not sure, we dont have klots in NZ.
2XT before you mix it smells like bubblegum. Last edited by noobi; 02-24-2012 at 10:57 PM. |
#13
|
|||
|
|||
I run amsoil dominator as did the previous owners of my bike, the inside of my motor was very clean when torn down with an oily coating on the powervalve and its bearings that wiped right off . Its also very easy to get around here I buy a gallon jug at a time from the local car parts place they're a amsoil dealer a local bike dealer sells it too.
IMO any named brand premix oil that wont gum up your powervalve will be fine. I run synthetic amsoil or rotella in my trans 0 40, 5 40 or 10 40 it works good and is easy for me to get. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
350 four stroke | 101racing | Other GasGas Bikes/Quads | 0 | 06-07-2009 10:58 PM |
2 Stroke oil | Silver | General Discussions & Announcements | 8 | 02-06-2009 07:49 PM |
2 stroke oil? | Elliker | Enduro Engine - 2 stroke | 5 | 01-22-2009 12:31 PM |
Does your GG 2 stroke, 4 stroke | stay_upright | Enduro Engine - 2 stroke | 1 | 05-22-2008 08:46 AM |