|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cylinder Head Braces
Has anyone ever sheared off the the braces that join the head to the frame up between the rads? Both of mine cracked, one at the head the other at the frame and I replace them only to have another one crack.
|
#2
|
||||
|
||||
Yes I Have On My Mc. Check All Motor Mount Bolts. I Found Mine Loose And I Believe That Was The Problem.
|
#3
|
|||
|
|||
That's what my dealer suggested as well. There was some play in the front one. I don't think the bolt backed off any...it seems like the case wore slightly to create a small gap. Tightened it all up and will see what happens after a few rides. Thanks!
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
cylinder head Question? | whodat | Enduro Engine - 2 stroke | 3 | 12-27-2008 12:54 PM |
EC300 Cylinder Head | Marcão | Enduro Engine - 2 stroke | 3 | 06-11-2007 03:52 PM |
New cylinder head | Kent A | Enduro Engine - 2 stroke | 8 | 05-01-2007 01:43 PM |