![]() |
|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Is there a replacement part for this? Or does the little rivetted in holder just drill out and you replace the nut? None of the parts diagrams actually give a part number for it, but 2011 shows it as a separate part...
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
#2
|
||||
|
||||
![]()
You have to drill it out and replace with a RivNut.
|
#3
|
|||
|
|||
![]()
Got a box of them so that's ok. Only concern is no nyloc?
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
#4
|
|||
|
|||
![]()
2011 has a black plastic washer under the seat pan that is a tight fit on the screw. It acts as a screw retainer. Unless I'm mistaken there is no nylock on the riveted nut assembly.
__________________
2011 EC250E |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
subframe, tall seat, plastic 03 | papagasgas | Parts | 3 | 04-24-2016 02:39 PM |
03 subframe air box seat | papagasgas | Parts | 0 | 09-20-2015 07:45 PM |
GasGas EC 2007 - 2011 subframe and seat | bonkeye | Parts | 1 | 03-26-2013 05:44 PM |
'012 Subframe/seat brace | gasgasman | Enduro Product Announcements | 14 | 03-22-2013 09:19 AM |