#31
|
||||
|
||||
Without a doubt F5. I'll just send it along with a few squish samples to someone who knows what they're doing
|
#32
|
||||
|
||||
Quote:
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#33
|
||||
|
||||
Tis the reason I'm considering putting it all in a box and a nice plastic cover over the flywheel. Surely I've gone mad!
|
#34
|
||||
|
||||
You won't! Getting too old to kickstart unnecessarily mate
__________________
'18 Gasgas XC250 |
#35
|
||||
|
||||
Head going into the mailbox today!
P-Tech radiator braces ordered! Rear wheel isn't very well aligned in the swingarm, but it'll be coming off for some rubber of choice at some stage anyway. Got the Renthal twinwalls off the old girl cleaned up and into the new one. Next stop will be along the lines of pulling the carb, chasing an NEDW needle down, fitting motion pro throttle cable and getting rid of that pull choke. |
#36
|
||||
|
||||
Ptech braces fit really well! Happy as a pig in it..
Have opted to pull the chain and rear sprocket straight up. Have a low hour used DID VX2 and Supersprox stealth 50T that I'll throw on. Still waiting for the head to come back, and tossing up OEM bashy vs AXP Extreme. Seeing what I can get a BPD swingarm guard for in Australia. Distributer is after $140+ postage selling to the public. I might be able to improve on this, otherwise I'll be taking my chances. |
#37
|
||||
|
||||
Have any of you people checked the PV linkage tension on the new bikes?
|
#38
|
||||
|
||||
Mine was pretty loose..
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#39
|
||||
|
||||
Ahh man! I didn't really want to have to go dropping the side cover off just yet!
Next question, appears the RHS pv cover is using a thicker gasket than I am used to. Is it required for clearance issues? I think I have a couple normal ones here still. |
#40
|
||||
|
||||
Yep you are all over it. The right hand side assembly is different to earlier ones. Be reall careful taking it of, mine was stuck down tight on one side. Depends too on where you run the adjustment screw as well. Mine is out pretty far, about three turns.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TSP head mod - 2018 EC250 | Gibnut | Enduro Product Reviews | 27 | 04-27-2019 09:25 PM |
2018 ec250 jetting help!! | Leelee | Enduro Intake/Carburetion - 2 stroke | 4 | 08-13-2018 07:59 AM |
2018 GG EC250 riders help please. | Gibnut | Enduro Engine - 2 stroke | 6 | 08-03-2018 06:10 AM |
Gas Gas 2018 EC250 Six Days - 4th ride | Gibnut | Pictures & Videos | 3 | 02-28-2018 12:07 PM |
Gas Gas 2018 EC250 Six Days | Gibnut | Enduro Product Reviews | 14 | 01-23-2018 12:00 AM |