|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Stator position
Hi all. In need of help I have a 2001 300ec and I'm trying to get it run better! At the top end of the power it feels flat and cuts out (feels more like ignition) on checking flywheel and stator I see you can adjust timing? Looks like 1deg is this correct and ok to do ? Thanks. It's a 2k3
Last edited by Goody4; 11-04-2011 at 04:53 PM. |
#2
|
||||
|
||||
which stator do you have? 2k2 or 2k3?
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#3
|
|||
|
|||
Spark plug or plug cap maybe?
__________________
Gas Gas EC 300 '06 BMW F650 |
#4
|
||||
|
||||
Coil HV wire where it connects to coil. The bond tends to break, they get loose and collect moisture.
|
#5
|
|||
|
|||
Took her on her 1st outing at weekend. Not bad. Still has issue with this cutting out! Will do at a constant throtle?? Now makes me think carbration !! Rich maybe ? Running 182 main 38 pilot
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What position do you run your bars? | BluegassXCR | General Discussions & Announcements | 14 | 10-08-2011 03:05 PM |
Rear brake position | Lildawg | Enduro Chassis & Body | 18 | 06-15-2011 11:17 PM |
Changing needle position? | EcEvan03 | Enduro Intake/Carburetion - 2 stroke | 6 | 04-27-2011 03:09 PM |
neddle position Question | biggstr6 | Enduro Intake/Carburetion - 2 stroke | 8 | 05-12-2010 10:26 AM |
Clip position ? | thingymijig | Enduro Intake/Carburetion - 2 stroke | 3 | 03-01-2007 04:57 AM |