|
|
|||||||
| All Other Bikes... KTM, Husky, VOR, Husaberg & Hondayamazuki... |
 |
|
|
Thread Tools | Display Modes |
|
#1
10-03-2013, 02:54 PM
|
|||
|
|||
Yamaha GYTR Wheel Kits
Does anyone know if these complete wheels will work on a gasser?
http://www.yamahamotorsports.com/spo.../0/detail.aspx
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar 
|
|
#2
10-04-2013, 10:33 AM
|
||||
|
||||
|
Quote:
Front brake disk is smaller diameter on the Yamaha (250mm on the Yamaha aganist 260mm on the gasser). Can be made to work by buying / making an oversize disk or moving the gasser's caliper. The front axle diameter on the Yamaha is smaller (could be fixed with other bearings, I presume). The rear one I don't know, but unless you usually win the lottery, I wouldn't bet on it.
__________________
Anders "So you know, that you're over the hill when your mind makes a promise that your body can't fill" (Little Feat: Old Folks Boogie) 2015 EC200 Racing: TE bars, Rekluse Core Exp 3.0, 38mm Lectron & Ohlins S3 steering damper 2006 EC200: 2011 plastics, Rekluse Z-Start, revalved KYB forks & Scotts steering damper 1998 Bimota Supermono 1986 Duc Mille S2 1975 Guzzi sidecar hack 1961 Morini Corsaro 125 etc
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ec300 piston kits? | motopsycho87 | Enduro Engine - 2 stroke | 2 | 08-01-2013 05:20 AM |
| Brake caliper kits | cladoo | Enduro Other... | 2 | 04-19-2012 06:47 AM |
| Graphic kits | NSE.ONE | Enduro Chassis & Body | 4 | 11-19-2009 06:03 AM |
| GasGas Bolt Kits? | JoeH | Enduro Chassis & Body | 5 | 07-01-2009 03:24 PM |
| graphic kits | 2stroker | Other GasGas Bikes/Quads | 0 | 11-02-2008 08:20 PM |
Linear Mode
