"08" EC125 Cylinder Pressure

[Luke811]

Originally Posted by kevells

Thank you for the replies so far, in answer to some of the questionsyou have raised, since owning the bike (about 3 months) it has always been the same in the lower rev range, does not pull at all in 1st &2nd gear (just like ridding with the choke on/mixture too rich!) I have had the reed block (V Force 3)out last night, they all seem to be sitting flat on their seats with no damage to the reeds!

The carb is a stock Keihin 38mm PWK
Main Jet 180
Slow Jet 48
Needle - NOZI set in middle position (have also tried in lowest notch)
Slide - G
Air Screw 11/2 turns out

Having spoken to Gas Gas uk the above is what they would recommend!
In the parts manual it shows a restrictor plate in the airbox for the 125 & 200, but mine does'nt have one - could this make the difference?

i think that the restrictor plate is that for the road version,because also mine GG 125 hasn't got...if I understand what you mean for "restrictor plate"

...and if it was useful http://www.facebook.com/pages/Gas-Ga...50354918326940



Luke