![]() |
|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I noticed when changing my gear oil an M6 threaded hole on the underside of the engine, Anyone know what it is? theres nothing in it just a threaded hole. Is this a breather or should it be plugged?
|
#2
|
||||
|
||||
![]()
If I'm not mistaken all theGasGas engines have another drain hole that is located towards the front of the motor under the crank area. That is used to drain any thing that might happen to get into main bearing area. That should have a bolt with a copper washer. Other than that an oil drain plug for the tranny. Anything else could just be a tapped hole with threads for mounting the cases to during assy process?
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals |
#3
|
|||
|
|||
![]()
on the pre-2005 bike it is a breather hole to the ign. and also a fixture hole for ass'y. Some guy's plug it with a screw.
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hole In Cylinder | PEB | Enduro Engine - 2 stroke | 1 | 09-07-2010 10:19 AM |
Ignition drain hole. | roostafish | Enduro Engine - 2 stroke | 3 | 11-28-2008 08:08 PM |
2008 Swing arm threaded hole ? | REVERUP | Enduro Other... | 7 | 11-21-2008 07:36 PM |
07 GG300EC - small hole at btm. of engine? | g dirt | Enduro Engine - 2 stroke | 4 | 02-26-2008 05:48 AM |
Mounting hole locations for Scotts Steering Stabilizer | SpeedyManiac | General Discussions & Announcements | 7 | 01-23-2007 01:33 PM |