Once again someone asking for jetting advice

[husley]

I searched the site but I have been out of the 2T loop for a while and most is the posts I found only helped a little bit.

Without asking for too much of your time:

I am looking for a middle-of-the-road starting point for my 2010 300.

4000-6000' 30-50'F

Just need some suggestions to get me started.

Thanks

J

p.s. Looking to error a little on the rich side and I prefer more linear power deliver

[husley]

I promise to never ask the other dreaded question "where should I send my suspension"

[iancp5]

I can't answer but have you spotted the other recent threads on ASI Vs ASII and the jetting database?

[swazi_matt]

not sure about the temp, but i am on similar elevation and think the place to start is to buy an N3EH needle, second clip and go down one size from stock on the main jet and standard on the pilot

[swazi_matt]

have you read this one?

http://www.gasgasrider.org/forum/showthread.php?t=8325

[husley]

This is what I found in the carb: (besides some old and nasty smelling fuel)

2010 300

Main 180

Pilot 40

NEF 3rd clip

Slide 7

How does this sound for 4000-6000' and 30-50' F ?

Thanks to all for your input

J